Note: This item only includes the 10 inch diamond disc for the model trimmer
Below is the description of the model trimmer.
Description:
1. Connect one end of the water tube to the nozzle of the wet model trimmer and the other end to the tap, open the valve
2. Connect the waste-disposal tube to the unit
3. Connect the power cord, and switch on the power switch (O=off, l=on)
4. When braking, it is normal to hear clicking before the sand tablet stops. If the sand tablet makes unusually loud noises, remove it,
and use the included hex-wrench to adjust the screw on the back cover (18)
5. To check if you need to replace the abrasive disk, rotate the disk by hand and estimate: if the platform jumps more than 2mm,
change the disk. After replacing the disk, make sure to tighten the ring on the platform 8 (closest to the outside of the sand tablet)
6. SKU: JT-D-19-001
Attention:
If there is some abnormal noise when working on
Possible reason:① Axon is loosing ② Disc is not plain enough。
How to solve it:①Dissemble the disc⒃ with spanner,make the snap
Ring tightly;② change the disc。
The machine does not work when power on
Possible reason:① fuse get burnt;② motor get burnt;③ switch get wrong。
How to solve it:① change the fuse(22) which inside the socket;② change the motor;③ change the switch.
Specification:
Voltage: <A>220V/50Hz±10% , <B>110V/60Hz±10%
Power: 500W Rotational Speed: 2800 rpm
Dimensions: 44×35×35cm Weight of the dental trimmer: 20kg
Dental Lab Equipment Dental Supplies Dental Equipment